Avocent Network Adapter EMS1000P Guía de usuario descargar pdf (Pagina 39)

l. Use the drop-down menus to enable or disable log in/out multisession notification and informational

message notification.

5. Click Next or click the Data Buffering link and use the drop-down menus to enable and configure data

buffering.

6. Click Next or click the Alerts link.

a. Click Enable Alerts to enable detection of alerts.

b. Click Add to add an alert string. In the Alerts String field, enter the string. In the Script field, enter the

shell script that will run when the match happens. Click Next to return to the Alerts screen.

NOTE: The console server allows an administrator to associate one shell script to the alert string. When there is a match with the alert

string, the console server will call the script passing the port number and the line where the match occurs as arguments.

c. Check the box next to an existing alert and click Delete to delete the string.

d. Click Delete Any to delete all strings whether selected or not.

NOTE: Clicking Delete Any will delete all alert strings. Selecting all the alert strings and clicking Delete is not the same functon as it will

not delete alert strings not shown in the table.

7. Click Next or click the Power link.

a. Click Add to add a new outlet. Click Selected PDU and select a PDU from the list of detected PDUs.

Enter the outlet(s) in the Outlets field, and click Next.

b. Check the box next to an existing merged outlet and click Delete to delete it.

NOTE: Power is only available when a single serial port is selected.

8. Click Save.

Parameter Description

Physical

Enable Cisco

RJ-45 Pin-Out Defines the serial port pinout. Default: Disabled.

Status Defines the status of the serial port as either enabled or disabled. Default: Disabled.

Speed

Defines the speed as 300, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 or 230400. Default:

9600.

Parity Defines the parity as either Even, Odd or None. Default: None.

Data Bits Defines the data bits as either 5, 6, 7 or 8. Default: 8.

Stop Bits Defines the stop bits as either 1 or 2. Default: 1.

Flow Control Defines the flow control as none, hardware, software, RxON software or TxON software. Default: None.

CAS

Port Name Name associated with the serial port (as an alias). Default: <appliance mac address>-p-<port number>.

Enable Auto

Discovery

The target name will be discovered and will be associated with this serial port. If it fails, the Port Name will

be used. Default: Disabled.

Table 3.5: CAS Profile Parameters

Chapter 3: Accessing the Console Server via the Web Manager 31

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 79 80

Sin comentarios

Avocent Network Adapter EMS1000P Guía de usuario Pagina 39