Avocent ECMS2000U Guía de usuario Pagina 23

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 92
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 22
Chapter 2: Installation 17
Installing the ECMS4000 User Station
Before installing your ECMS4000 user station, refer to the list below to ensure that you have all the
items necessary for installation.
Needed to install the ECMS4000 user station
Two External power supplies
Two IEC power cords
ECMS4000 User Station Quick Installation Guide
KVM cable
UTP cable (not supplied)
Three-wire serial cable or null modem cable (not supplied)
Needed for non-standard installations
To connect a VGA monitor to the user station, a DVI to VGA adaptor is required (not supplied).
Mounting option
The ECMS4000 user station mounts to the rear of a flat panel monitor via a mounting plate
accessory.
NOTE: Mounting accessories are ordered separately. Contact Avocent for more information.
Installation options
CAUTION:To reduce the risk of electric shock or damage to your equipment, disconnect the power from the user
station or transmitter by unplugging the power supply from the electrical outlet. To reduce the risk of electric
shock or damage to your equipment, turn on the remote workstation and the ECMS4000 user station in the order
described in the following procedures.
You can install the Emerge digital extender system with the ECMS4000 user station either by a
point-to-point or networked configuration.
Point-to-point installation
The following instructions will enable you to install your Emerge digital extender system in a
point-to-point configuration. In a point-to-point configuration, no administrator setup of the
ECMS4000 transmitter or the ECMS4000 user station is required. This enables you to install the
system quickly, directly out-of-the-box. However, if you choose the point-to-point configuration,
you can install only one ECMS4000 transmitter and ECMS4000 user station pair on a subnet and
must also locate both on the same subnet as well.
Vista de pagina 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 91 92

Comentarios a estos manuales

Sin comentarios