Avocent ECMS2000U Guía de usuario descargar pdf (Pagina 20)

14 Emerge Digital Extender System Installer/User Guide

Connecting power

The ECMS2000 user station features an external power supply. A DC power jack is located on the

rear of the ECMS2000 user station.

NOTE: Use only the power supply provided by Avocent.

To connect power to the ECMS2000 user station:

1. Plug the external power supply’s 2.5 mm connector into the DC power jack on the rear of the

ECMS2000 user station.

2. Connect the detachable IEC power cord to the power supply.

3. Plug the IEC power cord into an appropriate wall outlet.

Networked installation

The following instructions will enable you to install your ECMS2000 user station and ECMS2000

transmitter in a networked configuration. In this installation, multiple ECMS2000 transmitters and

ECMS2000 user stations are attached via the same Ethernet network. In this case, it is important for

each unit to be configured with a unique IP address.

NOTE: In Desktop and Extender Modes, the ECMS2000 user station and ECMS2000 transmitter can obtain their

IP address data from a DHCP server.

ECMS2000 transmitters and ECMS2000 user stations may be configured for use on a single subnet

or for use across routers. Use of routers, however, will cause a slight increase in end-to-end

latencies, which may not be acceptable for all applications.

8 Local Peripherals

(attached via USB)

9 ECMS2000 Transmitter

Table 2.3: Figure 2.3 Descriptions (Continued)

Number Description

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 91 92

Sin comentarios

Avocent ECMS2000U Guía de usuario Pagina 20