Avocent DSView 3 device license - 10 pack Guía de usuario Pagina 137

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 475
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 136
Unit type Status and Icon Icon Description
Any unit In Use The unit has at least one active connection.
Any unit Status Unknown
The status of the unit was reported to the software
but cannot be obtained for an unknown reason.
Target devices No Power The target device is powered down.
Target devices KVM Blocked
The connection path to the target device is blocked
because a cascade switch is already in use.
Target devices
No device attached
(topology view only)
N/A The port does not have a target device attached.
Target devices Partial Power
The DSView 3 software cannot determine the power
state of the target device, or the software received a
mixed power state from the target device. For
example, if a target device has a KVM connection and
a power device connection, the software will prompt
for a power status for both of these connections. If
both connections do not reply with ON or OFF, the
power status will display as Partial Power.
Managed
appliances
Not Responding
The managed appliance did not provide status
information. This may occur for multiple reasons,
such as the appliance is not powered up or it is
disconnected from the DSView 3 software system.
Action - Type of session that may be initiated. Although a unit may have multiple actions
that may be performed (for example, you may be able to access a target device using a
browser session or a Telnet session), only one action will be displayed.
NOTE: Actions are also available from Connections windows.
For example, a target device that is only attached to a serial console appliance will not
contain a KVM Session link. If a target device has a connection to both a serial
console appliance and a KVM switch, a KVM Session link will appear.
As shown in Figure 7.1, other available actions that have been enabled may be
accessed by clicking the Alternate Actions arrow to the right of the action with the
highest precedence. Clicking on one of the displayed links will launch the
corresponding window type.
Chapter 7: Units View Windows 121
Vista de pagina 136
1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 474 475

Comentarios a estos manuales

Sin comentarios