Avocent Access Router Cyclades-PR2000 Manual de usuario descargar pdf (Pagina 24)

Cyclades-PR2000

24Chapter 4 - Step-by-Step Instructions

STEP FIVE

A static route must be added to tell the router that all traffic not intended for the local LAN should be sent to the

Access Provider. Chapter 9 of the Installation Manual explains static routes and other routing methods

available in CyROS. Fill in the spaces in Figure 4.6 with the values for your application.

CONFIG=>STATIC ROUTES=>IP=>ADD ROUTE

Parameter Example Your Application

Destination IP Address Type in the word "DEFAULT".

Gateway or Interface

Interface

, because the IP addresses

are not known at configuration time.

Interface Slot 1 (SWAN) in the example.

Is This a Backup Route? No

OSPF Advertises This

Static Route

FIGURE 4.6 STATIC ROUTE MENU PARAMETERS

STEP SIX

NAT must now be activated. There are two varieties of NAT: Normal and Expanded. This example uses the

Normal NAT Mode. The other mode is explained in the chapter on NAT in the Installation Manual.

Menu CONFIG =>SECURITY =>NAT =>GENERAL

Parameter Example Your Application

Nat Status Enabled

Nat Mode Normal

Disable Port Translation No

FIGURE 4.7 NAT GENERAL PARAMETERS

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 135 136

Sin comentarios

Avocent Access Router Cyclades-PR2000 Manual de usuario Pagina 24