Avocent DSView 3 Guía de usuario descargar pdf (Pagina 5)

Large (>7000 Target

Devices)

Medium (1000-7000 Target Devices) Small (<1000 Target Devices)

1gbps/10gbps LAN

Local or remote data-

base

10mbps/100mbps/1gbps(recommended)

LAN

Local or remote database

10mbps/100mbps LAN

Local database

Transition Process

NOTE: In order to safely upgrade to the DSView 4 software, and to provide a roll-back path in case of upgrade

failures, perform each of the following steps. If your DSView 3 configuration does not include spoke servers, skip the

steps that refer to spoke servers.

Before you begin, ensure that you budget sufficient time to transition the hub and spoke servers

concurrently. The typical timeframe for transition is between 10 minutes and a couple of hours.

However, the amount of time required will vary depending on the amount of data and the

database size.

Transition Process:

1. Backup the DSView 3 hub server.

2. Backup DSView spoke servers (if you have spoke servers).

3. Install the DSView 4 software

a. New server installation

-or-

b. Installation on previous DSView 3 server. This scenario requires uninstalling DSView

3 software before DSView 4 software installation.

4. Using the export mode in the migration utility, create the database migration file.

5. Using the import mode in the migration utility, deploy the DSView 3 backup file, data and

migration file contents into the DSView software.

Data Replication

Perform a replication of all DSView 3 software spoke servers. In order to ensure that the entire

system has fully replicated, run the replication task twice to ensure that all spokes are in sync

with the hub server.

To initiate an immediate replication on a spoke server:

1. On the spoke server, click the System tab.

1 2 3 4 5 6 7 8 9 10 11 12 13

Sin comentarios

Avocent DSView 3 Guía de usuario Pagina 5