Avocent Network Adapter EMS1000P Guía de usuario descargar pdf (Pagina 31)

2. Select or deselect the Enable IPv4 checkbox to enable or disable IPv4 mode.

3. Enter the desired information in the Address, Subnet and Gateway fields.

4. Select either Enabled or Disabled in the DHCP drop-down menu.

NOTE: If you enable DHCP, any information that you enter in the Address, Subnet and Gateway fields will be ignored.

5. Click Save.

To configure IPv6 network settings:

1. From the side navigation bar, select Unit View - Appliance - Appliance Settings - Network - IPv6. The

Appliance IPv6 Settings screen appears.

2. Select or deselect the Enable IPv6 Stateful Configuration checkbox to enable or disable.

3. Enter the desired information in the Address, Gateway and Prefix Length fields.

4. Select either Enabled or Disabled in the DHCPv6 drop-down menu.

NOTE: If you enable DHCPv6, any information that you enter in the Address, Gateway and Prefix length fields will be ignored.

5. Click Save.

DNSSettings

You can choose to either manually assign theDNS server or to use the addresses obtained using DHCP or

DHCPv6.

To manually configure DNSsettings:

1. From the side navigation bar, select Unit View - Appliance - Appliance Settings - DNS. The Appliance DNS

Settings screen appears.

2. Select Manual, DHCP (if IPv4 is enabled) or DHCPv6 (if IPv6 is enabled).

3. If you selected Manual, enter the DNS Server numbers in the Primary, Secondary and Tertiary fields.

4. Click Save.

Local UI Settings

To change how the local UI is invoked:

1. From the side navigation bar, select Unit View - Appliance - Appliance Settings - Ports - Local Port UI to

open the Local Port UI Settings screen.

2. Under the Invoke Local Port UI heading, select the checkbox next to one or more of the listed methods.

3. Click OK.

Local port user settings

You can turn on or turn off local port user interface authentication and choose a user access level. If you turn on

local port user interface authentication, you will be required to log in to use the interface.

Chapter 3: Local and Remote Configuration 23

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 75 76

Sin comentarios

Avocent Network Adapter EMS1000P Guía de usuario Pagina 31