Avocent Network Device SPC420 Manual de usuario descargar pdf (Pagina 152)

132 DSView 3 Software Installer/User Guide

• Default target names allowed for connection types

This window is described in Adding Units on page 115.

Each of these options has a default value, which you may change.

To change the default values of the options in the Add Unit Wizard:

1. Click the System tab.

2. Click Global Properties in the top navigation bar.

3. Click Wizard Defaults in the side navigation bar, then click Add Unit Wizard.

4. The Add Unit Wizard Default Options window will open.

5. If you enable the Enable secure mode checkbox, by default, the unit will only be accessible by

this DSView 3 software system. In non-secure mode, the unit may be added to multiple

DSView 3 software systems.

6. If you enable the Allow target devices with the same name to be merged into a single target

device checkbox, by default, the connection to a target device in the appliance will be merged

with the connection(s) to an existing target device in the DSView 3 software database.

7. If a target device has a default name, you may indicate that, by default, it can be added to the

DSView 3 software database only if it supports specific connection type(s) in the appliance.

Enable the checkboxes for the specific connection types.

8. Click Save.

Topology synchronization options in the Resync Wizard

The Select Resync Options window in the Resync Wizard allows you to specify certain topology

synchronization options.

• Remove offline connections

• Delete target devices that no longer have connections

• Merge target device names

• Default target names allowed for connection types

This window is described in Resynchronizing units on page 315.

Each of these options has a default value, which you may change.

To change the default values of the options in the Resync Wizard:

1. Click the System tab.

2. Click Global Properties in the top navigation bar.

3. Click Wizard Defaults in the side navigation bar, then click Resync Wizard.

4. The Resync Wizard Default Options window will open.

• If you enable the Remove offline connections checkbox, by default, any appliance

connections that are reported as offline in the appliance will be deleted from the DSView 3

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 431 432

Sin comentarios

Avocent Network Device SPC420 Manual de usuario Pagina 152